+86-020-37781645

Analysis And Selection Of Brake Pads --CHM Brand

Aug 13, 2020

Brake pads are popular and vulnerable parts. I believe that friends often deal with them. Today, I will bring you some use case analysis.

1. It is reasonable for the brake pads to have a certain up-and-down eccentric wear. The high speed during the braking process causes the outer side of the brake pad to wear more than the inner side during use.

2. Severe eccentric wear caused noise. After inspection, the guide pin was stuck, and the guide pin grease was dry and hard, which caused the caliper to shift when it was working.

Measures: Clean the guide pin, grease the upper guide pin, and polish the old piece with sandpaper.


In winter, rainy season or wet weather, when the vehicle is stopped, the working surface of the brake disc is very easy to rust. Sometimes the working surface of the brake pad friction material will produce certain rust and form a certain stickiness between the surface of the brake disc. In the above weather conditions, the friction coefficient between the brake pads and the brake disc will increase instantly during the initial braking stage, resulting in abnormal braking noise. This kind of braking noise is more likely to occur after the brake pads are worn to a certain degree.

Measures: Under normal circumstances, the brake pads and brake discs do not require special maintenance or replacement. After a period of normal driving, the noise will disappear naturally.


CHM brake pad introduction:

Material 1: U.S. imported aramid, high toughness, high strength, high temperature resistance, friction material has good thermal decay resistance, stable braking force and more wear-resistant.

Material 2: Modified resin imported from Japan, which has a higher thermal decomposition temperature, improves the high temperature performance of the brake pads and reduces the wear rate.

At the same time, a layer of protection is added to improve the thermal conductivity of the friction fabric, increase the heat resistance of the brake pads, and prevent thermal degradation.

According to the noise test results of the brake pads, customized slotting and chamfering are carried out to reduce the noise rate in a targeted manner.

The automatic heat press precisely controls the pressure, time, temperature and exhaust times, with high quality consistency.

The computer-controlled high-speed automatic mixing center ensures accurate material ratio, full mixing, and stable formulation performance.

02

Send Inquiry