
Traditional Paraffin Thermostat
The paraffin thermostat mainly relies on the principle of thermal expansion and contraction of paraffin in the thermostat to control the opening and closing of the thermostat valve. Generally, when the water temperature reaches 80 degrees, the thermostat valve begins to open and operate until 95 degrees. Fully open.

Updated Electronic Thermostat
The engine module controls the operating current of the heating element in the electronic thermostat based on the engine's load, speed, water temperature, vehicle speed and other operating conditions, thereby adjusting the opening and closing angle of the thermostat.

Symptoms And Manifestations Of Damaged Thermostat
01 A damaged thermostat will cause the water temperature light on the instrument to alarm, indicating that the water temperature is too high.
02 The temperature of the upper and lower water pipes of the water tank is obviously different when you feel it with your hands. The temperature of the upper water pipe is very high, but the temperature of the lower water pipe is very low.
03 The electronic fan keeps working at high speed. Since the thermostat cannot be opened, the water temperature is too high. The body computer controls the electronic fan to cool down quickly, so the electronic fan will keep turning.
04 The engine fault light comes on on the instrument, and the fault information read by the decoder is a vehicle temperature sensor fault.
How To Diagnose Common Thermostat Faults
01 Test the car after replacing the thermostat. Note that the air must be drained after adding coolant. You can drain it several times to avoid air in the water channel causing the thermostat to fail to open normally, which is also one of the most common causes of failure.
02 For some models, after replacing the thermostat, the air is exhausted, but the water temperature is still too high, and the electronic fan turns the car. At this time, the fault code needs to be cleared, and restarting can solve the problem.
03 For electronic thermostats, in addition to the above two reasons, you also need to use a multimeter to check whether the electrical signal and resistance of the thermostat plug are normal.
04 Under normal circumstances, the most intuitive way to judge whether the wax thermostat is faulty is to remove the thermostat and boil it in water. If the thermostat valve opens after the water is boiled, it means it is normal, otherwise it is faulty.
