ADD: No.13 Dongping Middle Road, Baiyun District, Guangzhou, China
When the chassis is damaged in the field or far away from the repair site, the following emergency methods can be used to drive the car to the repair condition.
If the brake sub-pump leaks brake fluid or the sub-pump pipeline is broken, the sub-pump pipeline joint can be blocked by a small mat made of iron sheet and copper sheet, then the screw can be tightened, or the break is clamped flat and curled to stop the leakage, so that the wheel can not be used for braking. But this may result in unilateral braking and safety when driving.
Brake master cylinder lacks brake fluid, can be replaced by alcohol or liquor, under special circumstances can be replaced by clean water. Brake the bowl to swell. Soak the bowl in hot water for 10 - 20 minutes. Remove the oil from the bowl. This will restore the bowl to its original size.
The friction disc of the clutch can be skidded and slipped, and the friction disc which is not seriously burnt can be turned over. If ablation is serious, cotton cloth or canvas can be used several layers (the thickness should be the same as the original friction sheet), with steel wire or wire through the holes on the sheet to make it fixed. When driving a vehicle, it should start smoothly and shift gears quickly.
If the knuckle is broken, remove a bolt similar to the total length of the knuckle at the bumper or other places where it does not affect the running. Replace the broken knuckle. After loading the knuckle arm and nut, rivet the bolt with a hammer. If any of the differential gears of the middle and rear axles are damaged, the transmission shaft and the half axle of the bridge can be removed and continued to run. If the front differential is damaged, the hub connection can be removed and then continued.